LABEL INFORMATION PRODUCT SAFETY SYMBOLS The symbols below are used on the product to identify warnings, mandatory actions, and prohibited actions. It is very important for you to read and un- derstand them completely. Read and follow the information in the owner’s manual. Avoid exposure to rain, snow, ice, salt, or standing water whenever possible.
Page 5
LABEL INFORMATION Basic Operation Instructions Disposal and recycling-Contact your authorized Pride Provider for information on proper disposal of your Pride product and its packaging. Battery charger for indoor use only. www.silverstarmobility.com Removable Battery Pack...
Basic Operation Instructions INTRODUCTION WELCOME to Silver Star, a division of Pride Mobility Products Corporation (Pride). The product you have purchased combines state-of-the-art components with safety, comfort, and styling in mind. We are confident that the design features will provide you with the conveniences you expect during your daily activities.
Basic Operation Instructions INSTALLATION Battery Pack Installation to Exterior Lift Follow these steps to install the battery pack to the Exterior Lift: 1. Remove the battery pack from the battery base. 2. Align the mounting holes in the battery pack base bracket with those in the accessory bracket located under the key switch tube.
Battery Pack Installation to Backpacker Series Lifts Follow these steps to install the battery pack to a Backpacker Series Lift: 1. Remove the rubber caps and nuts from the protruding bolts on the side of the lift motor housing. See figure 2. 2.
Page 9
Basic Operation Instructions PROHIBITED! Do not mount the battery pack in an area where it will be affected by moisture or dirt. Follow these steps to install the battery pack to the SilverBoom: 1. Determine a location to mount the battery pack to the vehicle. See figure 3.
Do not expose to open flame. Avoid exposure to rain, snow, ice, salt, or standing water whenever possible. Maintain and store in a clean and dry condition. Battery charger for indoor use only. Removable Battery Pack Basic Operation Instructions www.silverstarmobility.com...
Basic Operation Instructions In House Docking Station Charging Follow these steps to charge the battery pack with the In House Docking Station: 1. Remove the battery pack from the battery pack base. 2. Place the charger base near a standard electrical outlet. See figure 4.
Backpacker Series/SilverBoom Battery Pack Charging The battery pack used on the Backpacker Series and SilverBoom is a self-contained unit, which includes 1 battery and an internal battery charger. The battery pack charger is designed to charge the lift battery and those of a mobility product, switching between the 12-volt lift battery and the 24-volt mobility product batteries, depending on which battery is in need of a charge.
2. Plug the charger cord into the off-board charger port on the mobility product. See figure 6. BATTERY CHARGER LEDs The LEDs on the side of the battery pack (see figure 8) indicate charging status. (See the table below.) Each battery has its own LED.
BATTERY REPLACEMENT MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling. WARNING! Always replace the battery with the exact same type, chemistry, and amp-hour (Ah) capacity.
Basic Operation Instructions TROUBLESHOOTING Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the battery is not fully charged or because the battery is worn down and can no longer hold a charge.
Page 16
In the event the battery pack’s fuse should cease to work: 1. Remove the fuse by pulling it out of its slot. The fuses are located on the underside of the battery pack. 2. Examine the fuse to be sure it is blown. See figures 12 and 13. 3.
Basic Operation Instructions CHARGER SPECIFICATIONS Operating Vehicle Voltage Operating Input Voltage Input Current (RMS): Input Fuse Output Fuse (One For Each Battery) Car Voltage minimum for auto shut-off Maximum Charging Current Onboard LEDs: (2) One For Each Battery Color: green www.silverstarmobility.com CONDITION 12.1V - 15.5V DC (Measured at car battery)
Page 20
Pride Mobility Products Corporation 182 Susquehanna Avenue Exeter, PA 18643-2694 Pride Mobility Products Company 380 Vansickle Road Unit 350 St. Catharines, Ontario L2R 6P7 Canada www.pridemobility.com www.silverstarmobility.com *INFMANU3630*...