Download  Print this page

Premier Mounts WMK-027 Installation Instructions Manual

Universal short throw wall mount
Hide thumbs

Advertisement

ViewSonic by Premier Mounts
Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044
©Premier Mounts 2009
9530-070-353-00

INSTALLATION INSTRUCTIONS

Universal Short Throw Wall Mount
NORTH AMERICA
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada –
Phone: 800-368-9700
Fax: 800-832-4888
WMK-027
EUROPE
Swallow House,
Shilton Industrial Estate,
Shilton, Coventry, England CV79JY
Phone: +44 (0) 2476 614700
Fax: +44 (0) 2476 614710

Advertisement

Table of Contents
loading

  Summary of Contents for Premier Mounts WMK-027

  • Page 1: Installation Instructions

    ViewSonic by Premier Mounts INSTALLATION INSTRUCTIONS NORTH AMERICA 3130 East Miraloma Avenue Anaheim, CA 92806 USA USA and Canada – Phone: 800-368-9700 Fax: 800-832-4888 Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044 ©Premier Mounts 2009 9530-070-353-00 WMK-027 Universal Short Throw Wall Mount...
  • Page 2: Table Of Contents

    PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE. PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACH-...
  • Page 3: Parts List

    This mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Premier Mounts (800) 368-9700. Wall Plate (Qty 1)
  • Page 4: Determining The Installation Height

    Center of the lens to the top of the PDS-PLUS bracket. Add 1.5” to the calculated total. This total distance will be the location for the bottom rail on the wall plate. Page 4 offset WMK-027 Lens Mark Top of Screen Ground Installation Instructions...
  • Page 5: Wood Stud Installation

    WMK-027 Wood Stud Installation Do NOT over-tighten lag bolts when attaching the mount to the wall. Improper installation may result in personal injury or damage to property. DEAD CENTER MUST BE LOCATED ON THE STUD FOR CORRECT AND SAFE INSTALLATION.
  • Page 6: Solid Surface Installation

    Do not overtighten. Step 8. Insert and gently tap the wall plate covers into place. WMK-027 Hammer Wedge Anchor Step 4. Once the holes have been drilled, place the concrete wedge anchors into the hole.
  • Page 7: Utilizing The Storage Feature

    WMK-027 Utilizing the Storage Feature The storage feature may be used to store electronic components. There is an accessible door on each side of the storage enclosure. It may be securely held shut with the use of four (4) M5 x 12mm security head screws. It may be easiest to pre-wire all cables down the arm (or extension) at this time (see Page 11).
  • Page 8: Throw Distance Calculation

    Step 4. Use a tape measure to mark the appropriate distance WMK-027. will be where the center of the mounting bracket will be located. If installing WMK-027, please refer to Page 10 before continuing. Page 8 Calculations X = Manufacturers recommended...
  • Page 9: Upper Mounting Bracket Installation

    WMK-027 Upper Mounting Bracket Installation Step 1. Insert the inner slide plate into the projector arm. Step 2. Determine which adjustment slot will be best for the projector placement. Step 3. Raise the upper mounting bracket into position. Step 4. Align the mounting holes of the upper projector plate with the mounting holes of the inner slide plate.
  • Page 10: Extension Arm Installation

    If the extension arm was purchased at a later date, the end cover must be removed prior to installing the extension arm. Step 1. Slide the extension arm into the open end of the WMK-027 (the front of the mount).
  • Page 11: Cable Management

    Step 1. The cable access holes are located at the end of the short throw mount and on the wall plate. Step 2. Route the cables through one end of the WMK-027 and out the other end. Set Screw Installation (Optional) The M6 set screw will be used in conjunction with any standard 1-1/2”...
  • Page 12: Technical Specifications

    WMK-027 Technical Specifications All measurements are in inches(mm). Page 12 Installation Instructions...
  • Page 13: Warranty

    What Premier Mounts Will Do At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is defective. If Premier Mounts chooses to replace a defective product or part, a replacement product or part will be shipped to you at no charge, but you must pay any labor costs.