Lenovo ThinkSystem RAID 930-24i Installation And User Manual page 5

ThinkSystem RAID 930-24i Adapter Installation and User Guide
1st Edition
Figure 1 Installing the ThinkSystem RAID 930-24i Adapter in a PCIe Slot
5. Connect SAS cables between the adapter and the SAS backplane or any other SATA device or SAS device.
The ThinkSystem RAID 930-24i adapter has six SFF-8643, internal x4, mini-SAS HD connectors. Use cables with an
external or internal mini-SAS HD connector on one end to connect to the adapter and the appropriate connector
on the other end to attach to the backplane or the SAS/SATA devices. Connectors must be cabled to specific drive
slots, as shown in the following table.
Connector
C0
C1
C2
C3
C4
C5
6. Replace the cover and reconnect any cords and cables, and power up the system. Replace the chassis's cover,
reconnect any power cords, and reconnect any network cables. Turn on the power.
7. Run the Human Interface Infrastructure (HII) Configuration Utility
Run the HII Configuration Utility to make any desired configuration changes. Refer to the ThinkSystem Storage
Adapter Software User Guide for detailed steps on drive configuration.
The hardware installation of your adapter is complete.
Bracket
Screw
3_03804
Edge of
Motherboard
Drive Slots
Drive slot 0-3
Drive slot 4-7
Drive slot 8-11
Drive slot 12-15
Drive slot 16-19
Drive slot 20-23
NOTE See Section 2.5.1, Board Layout, LEDs, Jumpers, and Connectors
more information about the connectors for your adapter.
Press
Here
Press
Here
PCIe Slot
- 4 -
Chapter 1: Hardware Installation
Hardware Installation Instructions
for