Advertisement
6
Pair the lock with your smart home system
If your controller is S2-compatible, please refer to the S2 Pairing Guide on the SmartCode 910 page at www.kwikset.com.
A
Initiate the pairing process at your smart
home controller. Refer to your smart home
system instructions for more information.
7
Add user codes (30 max)
It is recommended that you add and
delete all user codes through your smart
home control system. If your system
does not allow this, codes may be added
directly to the lock as shown here.
Programming Timeout
If no button is pressed for five seconds,
the system will time out and you will need
to restart the procedure.
8
Test the lock (review normal operation)
Confirm that the code(s) added in previous step can unlock the door.
Locking the Door
Press Lock button once.
9
Re-key the lock (if needed) and install the battery cover
A
Re-key the lock (if needed).
a
K
IMPORTANT:
Remove
battery
pack before
re-keying.
B
When prompted by your smart home system to
initiate pairing at the lock, press button "A" on the
lock interior one time. The red LED will illuminate
when pairing mode has been entered.
button "A"
Please allow time for the controller to pair with the lock.
A
Make sure the door is open. Press
the Program button the number of
times that corresponds to the user
code position being programmed.
Example: If
programming
the third code,
press the button
three times.
D
What lights and sounds does the lock produce?
One green flash with one beep*
green
1x
Programming was successful.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See "Switches and Status LED Colors" on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode, download the Programming
and Troubleshooting Guide on the SmartCode 910 page at www.kwikset.com.
c
b
Re-key the lock
Reinstall
to work with
battery
your existing key.
pack.
See the supplied
SmartKey
Re-key
instructions
H
for more
information.
B
Enter user code. A total of 30 user
codes may be programmed.
Each user code
must be a unique
code between
4 and 8 digits,
depending on
your smart
home system.
Three red flashes with three beeps*
or
red
3x
Programming was unsuccessful.
Make sure the user code is not a duplicate and that it is
between 4 and 8 digits during your next attempt.
Unlocking the Door
Enter user code.
Tip: You can press the
Lock button before
entering your user
code to light up the
keypad at night.
B
Install the battery cover.
K
a
3 / 4
C
If the pairing process is successful, re-name
the lock in your system (if applicable).
D
If pairing is unsuccessful, follow your system's
instructions to remove the lock from the controller and
any other network, then press button "A" on the lock
one time.
Perform steps 6A-6C again.
If pairing is still unsuccessful, consult the Programming
and Troubleshooting Guide on the SmartCode 910
page at www.kwikset.com.
C
Press Lock button once.
Two beeps*
or
Programming time out.
Make sure not to pause for more
than 5 seconds during programming.
b
M
2x
actual
size
V
V (3x)
Advertisement
