Related Manuals for Sangean U4
Summary of Contents for Sangean U4
- Page 1 Version 1...
- Page 2 ® The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by SANGEAN ELECTRONICS INC. is under license. ® Sangean U4 powered by Qualcomm aptX™ audio. Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries, used with permission.
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. - Page 4 For United States: Cautions to the user The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF exposure statements IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
- Page 6 Controls Battery locker WX LED indicator (Weather Alert LED NFC detection tag indicator) Display protection bar Battery charging indicator Preset button (Preset 3: Previous track Tuning control knob/Select/Seek button button/Preset 4: Play/Pause/Bluetooth pair Source button button/Preset 5: Next track button) Power button/Sleep button Alarm 1 button Speaker...
-
Page 7: Lcd Display
LCD Display RBDS indicator Alarm 1 and 2 indicator Weather Alert indicator Text/Frequency/Date display PM time indicator FM mode indicator Clock digits AM mode indicator Sleep indicator Bluetooth mode indicator Battery power status... - Page 8 Power the radio Note: No batteries are included with this radio. Back up battery is to back up the preset stations and also clock functions during power outage, not for formal radio operation. It is necessary to insert back up battery (2 x UM-3 1.5V, AA not supplied) for memory back up even if you use AC power only.
- Page 9 12Volt DC power adapter or DC power source not supplied for this device. "This product is intended to be supplied by a Listed Power Adapter or DC power source, rated 12Vdc, 1.2A min. and Tma 35 degree C min., if need further assistance, please contact SANGEAN for further information."...
-
Page 10: Rechargeable Batteries
IMPORTANT INFORMATION ON CHARGING AND USING RECHARGEABLE BATTERIES 1. Recharge the batteries in any case at least every 2 months. 2. Make sure the Battery Select switch inside the battery compartment is set to the “CHARGER” position. 3. Put the batteries in the compartment while paying attention to the correct polarity of the batteries (+ and -). - Page 11 Battery charging status indication Please note that the battery charging status detection can only be activated when the radio is in charging mode (i.e. the radio is switched off, the battery switch is in the NiHM position and it is connected to an AC outlet).
- Page 12 If you intend to charge the batteries but the charging indicator does not flash, it indicates the batteries are already fully charged. Display is then shown at right and it will switch to standby mode after 10 seconds. When there is no battery/missing batteries in the compartment or some of batteries are inserted with the incorrect polarity, display is shown at right and it will enter standby screen after 10 seconds.
- Page 13 Operating your radio – FM/AM Auto-Tune 1. Straighten the antenna. 2. Press the Power button to switch on your radio. 3. Press and release the Source button until the FM (1 or 2)/AM band is selected. 4. To scan up in frequency, first rotate the Tuning control knob in a clockwise direction and then press the Tuning control knob.
- Page 14 Setting tuning step 1. Turn off the radio. 2. Press and hold the Source button to enter the tuning step menu setting. 3. Rotate the Tuning control knob until FM xKHZ or AM xKHZ appears on the display, and press the Tuning control knob to enter FM or AM step setting.
-
Page 15: Weather Alert System
Presetting stations – FM/AM/WX You may store your preferred radio stations to the preset station memories. There are 20 memory presets in your radio 5 each for FM1, FM2, 5 AM and 5 WX. Presets are memorized by your radio in the event of a power failure. - Page 16 Setting the weather alert 1. Follow the steps above to tune to the required weather station. 2. Press and hold WX Alert button until Weather Alert indicator ( ) is shown on the display to activate the weather alert mode. The Weather Alert LED shows a steady red light. Note: When the radio is set to the weather alert mode, all the buttons on the front panel will be invalid.
- Page 17 Be aware that during the period of disconnection, no other Bluetooth device can pair or link with your radio. 3) If ‘SANGEAN U4’ shows in your Bluetooth device list but your device cannot connect with it, please delete the item from your list and pair the device with the radio again following the steps described previously.
- Page 18 U4. The unit will switch to Bluetooth mode and enter automatic pairing. If you pair with the U4 for the first time, your NFC-enabled device will be asked the permission to link with the radio. Once paired with a device, the Bluetooth icon will remain illuminated.
- Page 19 Clock Setting the clock automatically You can enable auto clock time adjustment by RBDS (Radio Broadcast Data System) CT function. Clock time can be automatically adjusted by an FM RBDS station. 1. You can access the menu setting when the radio is in power on or standby mode. 2.
- Page 20 Setting the date manually 1. Press the Info/Menu button until a beep sounds to enter the menu setting. Rotate the Tuning control knob until “DATE SET” shows on the display. Press the Tuning control knob to enter the setting. 2. Rotate the Tuning control knob to adjust the year. Then press the Tuning control knob to confirm the setting.
- Page 21 Alarms Your radio has 2 separate alarms which can be set to wake you to FM/AM radio or buzzer alarm. Each alarm can be set to sound once, daily, on weekdays or at weekends. The alarms can be set whether the radio is on or in standby mode. In the event of a power interruption your radio has a built in memory chip that will maintain your alarm settings for when the power is restored.
-
Page 22: Nap Timer
Snooze 1. When the alarm sounds, press any button other than the Power button will silence the alarm for 5 minutes. “SNOOZE” will appear on the display. 2. To adjust the silence time for the snooze timer, press the Info/Menu button until a beep sounds to enter the menu setting. - Page 23 Sleep timer - radio auto shut off Your radio can be set to turn off automatically after a preset time has elapsed. The Sleep Timer setting can be adjusted between 15,30, 45, 60, 90 and 120 minutes. 1. Press and hold the Power button to enter the Sleep Timer setting. “SLEEP XX” will show on the display.
-
Page 24: Auxiliary Input Socket
Auxiliary input socket A 3.5mm Auxiliary Input socket is provided on the right side of your radio to permit an audio signal to be fed into the unit from an external audio device such as iPod, MP3 or CD player. 1. - Page 25 USB socket for iPhone or Smartphone charging Your radio has a USB socket which is intended only for charging an iPhone or smart phone and similar devices. Charge time may vary and in some cases may take longer to charge than when using the manufacturers charging unit supplied with the smart phone.
-
Page 26: Specifications
Specifications Frequency Coverage: FM 87.50 - 108MHz AM 520 - 1710kHz (10kHz / step) 522 - 1710kHz (9kHz / step) WX 162.4-162.55MHz AC Power: AC 120V / 60Hz / 24W Batteries: 6 x UM-1 (D size) Approx. Battery life: Speaker=100mW The battery life is approx. - Page 27 FM/WX built-in bended spring antenna LED illuminator: 2 x white LED, current consumption 30mA Sangean reserves the right to amend the specifications without notice. If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste.