Download  Print this page

Cleaning The Unit Exterior, Hand Drying Area And Air Inlet; Cleaning The Area Around The Unit - Mitsubishi Electric JT-S2AP-S-NE Instruction Manual

Jet towel hand dryer
Hide thumbs

Advertisement

Maintenance - Continuation

Cleaning the unit exterior, hand drying area and air inlet

1
1
Turn the ground-fault circuit interrupter "OFF".
2
Wipe the unit exterior and the hand drying
area with a tightly wrung out piece of cloth.
When it is unclean, wipe it with a piece of cloth that has
been soaked in neutral detergent and tightly wrung out,
thoroughly remove the remaining neutral detergent and
wipe it with a dry piece of cloth.
Please be sure to wipe with a piece of cloth that has
been wrung out tightly as water may enter the unit and
cause damage if it is wiped with a very wet piece of
cloth.
Clean the sensor area.
※ The sensor may lose its sensitivity and malfunction if
the transparent surface inside the hand drying area
is covered with a white-coloured substance.
Do not use alcohol to wipe the front
Caution
cover of JT-S2AP.
Prevent scratching on the front cover. Rust
NOTE
may form on the scratched area.
(JT-S2AP only)
3
Wipe the air inlet with tightly wrung cloth.
Brush off dust on the fi lter.
Clean the air inlet periodically.
A clogged internal fi lter may slow down the air speed.

Cleaning the area around the unit

2
Clean the fl oor under the unit and the wall around the unit periodically.
Front cover
Hand drying area
Nozzle
8
Exterior
Air inlet
Brush, etc.
Sensor

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jt-s2ap-w-neJt-s2a-w-ne