6) Resale: In the event of resale to a third party, it is imperative that all manuals and warning and cautions be made available to the new owner. Premier Heat Pumps – Water Heater and Chiller Manual Page 2...
Unit must be installed in accordance with AS/NZS 3500.4 : NZBC G12 Complies with CE and New Zealand Safety Standards including; AS/NZS 60335 AS/NZS 4692 : AS/NZ 2712 Specifications may be amended from time to time without prior notice. Premier Heat Pumps – Water Heater and Chiller Manual Page 4...
Any additional disinfectant systems, such as chemical or electrolysis are not recommended for use with this hot water heat pump. The pump MUST be installed prior to these systems. For optimal operation of the heat pump, the following maximum values apply: A.
2 - Description of the Heat Pump 2-1 Outside Premier Heat Pumps – Water Heater and Chiller Manual Power Plug Control Panel Air Inlet Air Outlet Temperature Sensor Drainage Cold Water Inlet Hot Water Outlet Page 6...
NB: Product sound measurement is tested in the factory before shipping. “Dimensions and Technical Characteristics” data table shown above is accurate at the time of publication. Premier Heat Pumps reserves the right to amend the unit specifications without prior notice. Product code plate affixed to the individual unit reflects the specifications of the individual unit.
3 - Installation 3-1 Locating the Unit It is important to install the hot water heat pump in accordance with the following instructions. Water and electrical connections must be carried out by a suitably qualified tradesman or installer • The appliance must be installed outside.
Attention: Be sure the tank is full of water before it is switched on. Warning: The inlet and outlet plastic caps are for transport only. Any unused inlet or outlet ports must be blanked off properly using compliant metal pipe caps. Premier Heat Pumps – Water Heater and Chiller Manual Page 10...
• The plug must be safe, protected from rain and water and the condition checked regularly Before starting the heat pump hot water cylinder, it is important to fully read this manual and understand the operation and the settings. Premier Heat Pumps – Water Heater and Chiller Manual...
By using the free energy contained in the ambient air, the heat pump enables the heating of the water in a very economical way. Your heat pump is a heat machine that can transfer the heat from a low temperature area (ambient air) to a higher temperature area.
1,2,...24,1,2 (The display shows the previous time as the starting time of the present setting) Premier Heat Pumps – Water Heater and Chiller Manual when the unit has received the signal it gives out...
Page 15
3) After exiting the defrost mode, the heater will stop operation for 3 minutes, then it will run in the mode before defrosting. (This key is invalid for single mode water chiller) Premier Heat Pumps – Water Heater and Chiller Manual button again, and the set up is cancelled. Page 15...
1 minute and begins to work. The compressor restarts after it has stopped for 3 minutes. If the sensor for T4 is damaged, the system begins to defrost, after the compressor has run continuously for 45 Premier Heat Pumps – Water Heater and Chiller Manual Page 16...
• Check the mandatory labelling and the operation of the unit • Check the safety measures • Check the pressure of the refrigerating gas • Clean the electric box and control the connections • Check the electrical connections Premier Heat Pumps – Water Heater and Chiller Manual Page 17...
The pressure of the manometer is right Premier Heat Pumps – Water Heater and Chiller Manual Probable Cause Explanation/Solution Check the plug and No electrical feed or electrical connection. power supply...
Need help?
Do you have a question about the PHP HWC-150 and is the answer not in the manual?
Questions and answers