Vacuum With A Bag Of The Bag Roll - CASO DESIGN 1420 Instruction Manual

Close the lid. Set the desired sealing time with from 3-9 with "+" or "-" and the desired
vacuum time from 5-60 seconds.
Press „START". The device automatically vacuums and seales the bag. The
display counts down vacuum and sealing time.
At any time you can end the vacuum process with „SEAL", then the bag will
be sealed directly.
Wait until the device lets the air in again and a signal tone is emitted. "CLO"
is shown in display. Now you can open the lid and take out your bag.

16.2 Vacuum with a bag of the bag roll

Place the unit on a dry surface.
Connect the device to a grounded wall outlet. The LED display shows "OFF".
Open the lid of the appliance.
Press "ON/OFF". The LED display shows "ON".
Place the piece of roll over the sealing bar. Pinch the open end firmly under the clamp of
the fixation. For this shortly lift the clamp.
Close the lid of the device.
Set with "+" the sealing time to 9.
"CLO" is shown in display. Now you can open the lid and take out your customized bag.
► You can make settings only when the device is "ON". You can see this in the display.
► Cut the bag at least 8 cm longer than needed. The sealed ends will take up the extra
space.
► Do not overstuff the bag; leave enough empty length in the open end of the bag (at least
a few inches) so that the bag can be properly placed in the vacuum chamber.
► Do not wet the open end of the bag. Wet bags may not seal properly.
► Clean and straighten the open end of the bag before sealing. Foreign matter or creases
on the bag may result in a faulty seal.
► Press the bag to expel excess air before vacuuming it. Too much air inside the bag may
result in a poor vacuum.
► If the food you're sealing has sharp edges (such as bones or shells) pack the edges
with kitchen paper to avoid tearing the bag
caso Vacu Chef 77
Press START and then press SEAL directly.
The vacuum pump is working shortly. The piece of roll will be sealed
and one end.
Wait until the device lets the air in again and a signal tone is emitted.
PLEASE NOTE
32