Connecting A Av Receiver; Connecting Headphones; Understanding The Basics; Selecting The Video Input Source - Hisense LHDN32V88MH User Manual

Understanding the basics

Connecting a AV receiver

Connecting using a digital audio cable
To connect using a digital coaxial cable:
1 Make sure that your TV's power cord is unplugged and the AV
2 Connect one end of a digital
the DIGITAL AUDIO OUT jack on the back of the TV.
AV Receiver
3 Connect the other end of the audio cable to the digital
input jack on the AV receiver.
To play TV sound through a AV receiver:
1 Turn on the TV and select a program to watch.
2 Turn on the AV receiver and select the TV sound source,
then adjust the volume to a comfortable level.

Connecting headphones

Warning: When using headphones, adjust the headphone volume to
avoid excessively loud volume which can damage your hearing.
To connect headphones:
Plug the headphones (not included) into the
jack on the back of the TV.
Note: The TV sound automatically mutes when headphones are
connected period.
HDMI3
COMP 2
Y P
B
L
DIGITAL AUDIO OUT
AUDIO OUT
coaxial audio cable (not included) to
Back of TV
DIGITAL
AUDIO OUT
Digital coaxial cable
coaxial
(headphone)
HDMI2 HDMI1
HEADPHONE SERVICE
P L R
R
S-VIDEO
R VIDEO L R
AV
Back of TV
LHDN32V88MH / LTDN42V77MH
Understanding the basics
1 Plug the power cord into an AC power outlet.
2 Press (power). Your TV turns on.
3
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.

Selecting the video input source

To select the video input source:
1 Turn on your TV, then press INPUT on the remote control or on
the TV. The INPUT SOURCE menu opens.
2 Press or to highlight the video source you want, then press
ENTER. Options include TV, AV, YPbPr1,YPbPr2, VGA (computer),
HDMI1,HDMI2,HDMI3,HDMI4,S-VIDEO.

Selecting a channel

Tip: If you are using a cable or satellite box, use the remote control that
came with that device to change channels.
To select a channel:
Press CH /CH
Press the number buttons to enter the channel number you want,
then wait for the channel to change, or press ENTER to change
the channel immediately.
To select a digital channel, press the number buttons to
select the main digital channel, then press the dash(-). button,
then the number buttons again to select the sub-channel.
Wait for the channel to change or press ENTER to change the
channel.
Note: Button presses must be within three seconds of each other.
Press LAST to go to the last channel viewed.
Press GUIDE to display a list of memorized channels, press or
to select the channel you want from the list, then press ENTER to
go to that channel.
Note: If the list has more than one page, press
the pages.

Adjusting the volume

To adjust the volume:
Press VOL /VOL
Press MUTE
to restore the sound.
.
to go to the next or previous channel.
or to scroll through
to increase or decrease the volume.
MUTE again
9