Installation - GE L30 Instruction Manual

Line current differential system, ur series
Hide thumbs Also See for L30:
Table of Contents

Advertisement

5.2 PRODUCT SETUP
Use the MENU key to go to the user displays menu to view the user-defined content. The current user displays will show in
sequence, changing every four seconds. While viewing a user display, press the ENTER key and then select the 'Yes"
option to remove the display from the user display list. Use the MENU key again to exit the user displays menu.
An example user display setup and result is shown below:
 USER DISPLAY 1
5
USER DISPLAYS
If the parameters for the top line and the bottom line items have the same units, then the unit is displayed on the
bottom line only. The units are only displayed on both lines if the units specified both the top and bottom line items
NOTE
are different.
PATH: SETTINGS
PRODUCT SETUP
 INSTALLATION
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until
RELAY SETTINGS
UNIT NOT PROGRAMMED
The
setting allows the user to uniquely identify a relay. This name will appear on generated reports.
RELAY NAME
5-58
DISP 1 TOP LINE:
Current X
DISP 1 BOTTOM LINE:
MESSAGE
Current Y
DISP 1 ITEM 1:
MESSAGE
6016
DISP 1 ITEM 2:
MESSAGE
6357
DISP 1 ITEM 3:
MESSAGE
0
DISP 1 ITEM 4:
MESSAGE
0
DISP 1 ITEM 5:
MESSAGE
0
Current X
Current Y


INSTALLATION

RELAY SETTINGS:
Not Programmed
RELAY NAME:
MESSAGE
Relay-1
is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
self-test error message is displayed until the relay is put into the "Programmed" state.
L30 Line Current Differential System
Shows user-defined text with first tilde marker.
~
A
Shows user-defined text with second tilde marker.
~
A
Shows decimal form of user-selected Modbus register
address, corresponding to first tilde marker.
Shows decimal form of user-selected Modbus register
address, corresponding to second tilde marker.
This item is not being used. There is no corresponding
tilde marker in top or bottom lines.
This item is not being used. There is no corresponding
tilde marker in top or bottom lines.
This item is not being used. There is no corresponding
tilde marker in top or bottom lines.
Shows the resultant display content.
0.850
0.327 A
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5 SETTINGS
5.2.16 INSTALLATION
GE Multilin

Advertisement

Table of Contents
loading

Table of Contents