Table of Contents
Advertisement
Levelling of the appliance
Use small feet on the bottom of appliance to set
the appliance top surface level with other
surfaces.
Anti-tilt protection
CAUTION!
Install the anti-tilt protection to
prevent the appliance from falling
under incorrect loads. The anti-tilt
protection only works when the
appliance is put in a correct area.
Your appliance has the symbols
shown on the pictures (if applicable)
to remind you about the installation
of the anti-tilt protection.
CAUTION!
Make sure you install the anti-tilt
protection at the correct height.
24
Make sure that the surface behind the appliance
is smooth.
1. Set the correct height and area for the
appliance before you attach the anti-tilt
protection.
2. Install the anti-tilt protection 176 mm down
from the top surface of the appliance and
24 mm from the left side of the appliance
into the circular hole on the bracket. See
the illustration. Screw it into the solid
material or use applicable reinforcement
(wall).
3. You can find the hole on the left side at the
back of the appliance. See the illustration.
Put the appliance in the middle of the space
between the cupboards (1). If the space
between the bench cupboards is larger
than the width of the appliance, you must
adjust the side measurement to centre the
appliance.
Electrical installation
WARNING!
The manufacturer is not responsible
if you do not follow the safety
precautions from Safety chapters.
This appliance is supplied without a main plug
or a main cable.
Applicable types of cables for different phases:
Phase
1
3 with neutral
24 mm
1
Min. size cable
3x6.0 mm²
5x1.5 mm²
www.zanussi.com
Advertisement
Table of Contents
