Description Of The Appliance; Preparing The Appliance - Kärcher T-Racer T 400 Plus User Manual

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
 See page 2, illustration
1 Casing
2 Handle
3 Turning handle "power" (to adjust the
height of the nozzles)
4 Foot pedal for edge cleaning
5 Foot pedal for surface cleaning
6 Bayonet connection with safety cover
7 Extension tubes (two tubes)
8 Rotor arm
9 Green high-pressure nozzle
10 Yellow high-pressure nozzles (2 pieces)
11 Grey high-pressure nozzles (2 pieces)
12 Safety clip
13 Protective grid

Preparing the Appliance

Selecting the high-pressure noz-
You need to use the matching high-pres-
sure nozzles to ensure that your high-pres-
sure cleaner works properly.
Note: Nominal pressure (p): See Operating
Instructions or type plate of your high-pres-
sure cleaner.
High-pressure cleaner with nominal
pressure (p) of 13 MPa (130 bar) to 16
MPa (160 bar)
e.g.: K 6 – K 7, Kärcher 600 – Kärcher 770
 Use yellow high-pressure nozzles.
Note:The yellow high-pressure nozzles
have already been installed.
High-pressure cleaner with nominal
voltage (p) lesser than 13 MPa (130 bar)
e.g.: K 4 – K 5, Kärcher 201 – Kärcher 560
 Use grey high-pressure nozzles.
8
zles
Changing the high-pressure nozzles
 Illustration
1 Loosen the safety clamp with a screw-
driver.
2 Remove the protective grid.
3 Change the high pressure nozzles.
a Remove the clip.
b Pull out the yellow high-pressure noz-
zle.
c Insert the grey high-pressure nozzle.
d Re-insert the clip.
4 Mount the protective grid on the pin.
5 Push the safety clamp in until it locks.
Application
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Cleaning floor surfaces
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
 Illustration
1 Screw the two extension pipes together.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
 Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
 Adjust the turning handle "power" as
per the surface to be cleaned
– 5
EN