Mounting To The Supply Duct; Remove The Steam Guide; Prepare The Steam Nozzle; Install The Stam Nozzle - Honeywell HM750 Installation Instructions Manual

HM750A1000

Mounting to the Supply Duct

The HM750 can also be mounted directly onto the supply
duct. In this case, the steam guide must be removed and
replaced with the steam nozzle and baffle as follows:

REMOVE THE STEAM GUIDE

CAUTION
Do not remove the cover when the humidifier
powered.
1. Remove the humidifier front cover.
2. Remove the cylinder plugs and high water sensor
plug from the cylinder pins by pulling vertically.
3. Loosen the hose clamp furthest from the cylinder
steam outlet (the one attached to the plastic steam
guide). Remove the cylinder with the short steam
hose still attached. See Fig. 15.
4. Remove the hose adapter by pressing on the release
tab toward the back of the humidifier and sliding the
hose adapter down.
4. SLIDE DOWN
HOSE GUIDE
Fig. 15. Changing to duct mount configuration.

PREPARE THE STEAM NOZZLE

1. Locate the supplied steam nozzle and baffle.
2. Insert the baffle into the duct-mount nozzle.
NOTE: There is a keying feature on the baffle that
ensures proper orientation of the baffle in the
nozzle.
Fig. 16. Insert baffle into the duct-mount nozzle.
Key ensures proper alignment.
33-00289—01
INSTALL THE STEAM NOZZLE
1. Install the nozzle with baffle directly onto the
2. Insert cylinder base into drain valve. Press down on
3. Rotate the cylinder back in place while guiding the
4. Secure the steam hose to the duct mount nozzle with
5. Reconnect the cylinder plugs and high water sensor
MOUNT HUMIDIFIER ON DUCT
1. Using the duct mount template supplied with the
2. Following the template, drill a 1-3/4" hole in the
3. Insert the top screw until 1/4 in. (6 mm) is exposed.
NOTE: The donut-shaped foam gasket must be installed
4. After making sure the humidifier is level, secure it to
1. REMOVE WIRE PLUGS
LOOSEN HOSE CLAMP
3. PRESS ON
RELEASE TAB
2. TILT OUT TO
REMOVE CYLINDER
M37218
10
humidifier at the location where the hose adapter
was removed. It clicks into place.
the cylinder to ensure it is properly seated in the
drain valve, otherwise it could leak
short steam hose attached to the cylinder onto the
duct mount nozzle.
the hose clamp. Do NOT overtighten, or the duct
mount nozzle could be damaged.
plug to the cylinder pins.
humidifier, locate the template on the side of the
duct where the humidifier will not interfere with the
operation or maintenance of the furnace.
duct to insert the duct mount nozzle.
Hang the humidifier via its keyhole on the screw
head (see Fig. 17).
between the humidifier and the duct.
the duct using two screws at the duct-mount
locations (Fig. 12), and then replace the cover
FOAM
GASKET
AIR FLOW
Fig. 17. Duct mount. Install foam gasket between
humidifier and air supply duct.
MOUNTING
SCREWS
AIR DUCT
M37197