Manufacturer's Federal Communications Commission Declaration Of Conformity Statement - Cisco 7920 Regulatory Compliance And Safety Information Manual

Additional information can also be obtained from the following organizations:
•
•
•
Manufacturer's Federal Communications Commission Declaration of
Conformity Statement
Models: Cisco 7920 Wireless IP Phone
FCC Certification Number: LDK102043
Manufacturer: Cisco Systems, Inc.
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1.
2.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
•
•
•
•
The Part 15 radio device operates on a non-interference basis with other devices operating at this
Caution
frequency. Any changes or modification to said product not expressly approved by Cisco, including the
use of non-Cisco antennas, could void the user's authority to operate this device.
78-15421-01
D R A F T - C I S C O C O N F I D E N T I A L
World Health Organization Internal Commission on Non-Ionizing Radiation Protection at
www.who.int/emf
United Kingdom, National Radiological Protection Board at www.nrpb.org.uk
Cellular Telecommunications Association at www.wow-com.com
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
Regulatory Compliance and Safety Information for the Cisco 7920 Wireless IP Phone
Regulatory Compliance
5