Makita AF353 Instruction Manual page 8

The air supplied to the tool can also be used as an air
duster. You can clean the work area by pressing the
button on the grip end.
1
► 1 . Button
NOTICE:
After using the air duster, the driving force
of the tool will temporarily decline. Wait until the air
pressure recovers in this case.
NOTICE:
Perform a test blow if you use the air
duster immediately after the oil was applied. The oil
may be sprayed with the air.
ASSEMBLY
CAUTION:
Before carrying out any work on
the tool, always return the trigger and lock lever
and disconnect the hose.
Loading pin nailer
CAUTION:
Hold the sliding door when press-
ing the unlock button. In case pin nails are loaded in
the magazine, the sliding door moves suddenly when
pressing the unlock button.
CAUTION:
Always move the sliding door
slowly and carefully. Accidentally dropping pin nails
especially when working in high places may cause
personal injuries.
CAUTION:
Load the same type, size and
uniform length of nails when loading nails in the
magazine.
NOTICE:
Load pin nails in the correct direction.
Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other
parts.
NOTICE:
Do not use deformed connected pin
nails. Use pin nails specified in this manual. Using
pin nails other than those specified may cause pin
nail jamming and breakage of the pin nailer.
1. With holding the sliding door, press the unlock
button and move the sliding door to open.
► 1 . Unlock button 2. Sliding door
2. Place pin nails against the magazine and insert
into the slit all the way. Be careful to place pin nails in
the right direction.
3. Keeping pin nails in this position, slide these nails
all the way into the driver guide.
2
► 1 . Pin nails 2. Driver guide
4. Return the magazine to the original position until
unlock button pops up.
Dimensions of nails
Only the following fasteners can be used with the tool.
23 Gauge pin nails
8 ENGLISH
1
2
1