Post-Installation Instructions - Acer Altos G520 series User Manual

38
3 Open the system according to the instructions beginning on page
39.
4 Follow the ESD precautions described in this section when
handling a server component.
5 Remove any expansion board(s) or peripheral(s) that block access
to the DIMM socket or other component connector.
See the following sections for specific installation instructions on the
component you want to install.
Warning! Failure to properly turn off the server before you start
installing components may cause serious damage. Do not attempt
the procedures described in the following sections unless you are
a qualified service technician.

Post-installation instructions

Observe the following after installing a server component:
1 See to it that all components are installed according to the
described step-by-step instructions.
2 Reinstall any expansion board(s) or peripheral(s) that you have
previously removed.
3 Reinstall the air baffle.
4 Reinstall the chassis panels.
5 Connect the necessary cables.
6 Turn on the system.
3 Upgrading the system