Pioneer PDP-434CMX Service Manual page 191

5
Installation using the optional PIONEER stand or
installation bracket
÷ Please be sure to request installation or mounting of this
unit or the installation bracket by an installation
specialist or the dealer where purchased.
÷ When installing, be sure to use the bolts provided with
the stand or installation bracket.
÷ For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the PIONEER
stand or installation bracket (sold separately)
÷ When possible, please install using parts and
accessories manufactured by PIONEER. PIONEER will
not he held responsible for accident or damage caused
by the use of parts and accessories manufactured by
other companies.
÷ For custom installation, please consult the dealer where
the unit was purchased, or a qualified installer.
b hole
b hole
a hole
b hole
CAUTION
To avoid malfunction, overheating of this unit, and possible
fire hazard, make sure that the vents on the main unit are
not blocked when installing. Also, as hot air is expelled
from the air vents, be careful of deterioration and dirt build
up on rear surface wall, etc..
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only
this size bolt can be used.)
5
6
Air vents (fan)
b hole
a hole
b hole
Center line
Rear view diagram
PDP-504CMX/1
6
7
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc.. The installation holes that can
be used are shown in the diagram below.
÷ Be sure to attach in 4 or more locations above and
below, left and right of the center line.
÷ Use bolts that are long enough to be inserted 1/2 inch
(12 mm) to 11/16 inch (18 mm) into the main unit from
the attaching surface for both a holes and b holes.
Refer to the side view diagram below.
÷ As this unit is constructed with glass, be sure to install it
on a flat, unwarped surface.
Main unit
Center line
b hole
1/2 inches (12 mm) to
11/16 inches (18 mm)
Side view diagram
CAUTION
Because this unit weighs about 88 lbs 3 oz (about 40 kg)
and the lack of depth makes it fairly unstable, please use 2
people or more when packing, carrying or installing.
CAUTION
This unit incorporates a thin design. To ensure safety if
vibrated or shaken, please be sure to take measures to
prevent the unit from tipping over.
7
8
Attaching surface
Installation
bracket,etc..
a hole
Bolt
1/2 inches (12 mm) to
11/16 inches (18 mm)
Bolt
b hole
191
8
A
B
C
D
E
F