Using The Accessories - Kärcher K 3.000 Operator's Manual

STEP 5:
Connect garden hose to the cold water source
and turn water on completely.
STEP 6:
Plug the Ground Fault Circuit Interrupter
(GFCI) into a working outlet.
We recommend that you test the GFCI as part
of your startup procedure each time you use
your pressure washer. Plug the GFCI into the
outlet, press the reset button, press the test
button and then press the reset button again.
WARNING
Do not use if above test fails.
WARNING
To avoid serious injury, never point spray
nozzle at yourself, other persons or animals.
Always test an inconspicuous area before
cleaning with high pressure.
Vario Power Spray Wand
The Vario Power Spray Wand allows you to adjust
the cleaning pressure.
To clean at maximum pressure, the wand must
be positioned to the high pressure setting
(Max).
8 English
OPERATING INSTRUCTIONS

USING THE ACCESSORIES

Note: The actual appearance of the GFCI may
be different from this illustration.
STEP 7:
Unlock the trigger gun safety lock. Trigger the
gun to eliminate trapped air, then wait for a
steady flow of water to emerge from the spray
nozzle.
STEP 8:
Turn on the high pressure washer by turning
the switch to the (I / ON) position.
The motor runs only while the trigger of the
gun is pulled and shuts off when the trigger
is released.
For lower pressure turn the wand collar in the
minus (Min) direction.
To apply detergent, the wand must be posi-
tioned to the lower pressure setting (Mix).