GE C70 Instruction Manual page 202

Capacitor bank protection and control system
Hide thumbs Also See for C70:
Table of Contents

Advertisement

FLEXLOGIC DESIGN USING ENGINEER
Place and configure a FlexElement. A FlexElement is a universal comparator used to monitor any analog actual value
calculated by the relay or a net difference of any two analog actual values of the same type.
Place and configure the Settings Group settings
Place and configure a Selector Switch element. Firmware version determines feature availability. The Selector Switch
element is intended to replace a mechanical selector switch. Typical applications include setting group
control or control of multiple logic sub-circuits in user-programmable logic. The element provides for two control inputs.
Place and configure a Digital Element. A Digital Element can monitor any FlexLogic operand
and present a target message and/or enable events recording depending on the output operand state.
Place and configure a Digital Counter element. A Digital Counter counts the number of state transitions
4
from Logic 0 to Logic 1. The counter is used to count operations such as the pickups of an element.
4.4.7.3 Basic Actions toolbar
Select
Edit Vertices
Properties
Zoom Normal
Zoom to Fit
Zoom Custom
Pan
Align Top, Middle, Bottom
Align Left, Center, Right
Space Across
Space Down
Same Width
Same Height
4-84
Select components. Click one component and hold down the CTRL key to select others.
Or click and drag an area that contains multiple components to select.
Shows vertices points for the component selected (if the component support vertices
manipulation)
Shows the properties of the selected component
Zoom in and center the screen to the spot selected
Zoom in to a magnitude that fits your entire schema layout on your entire screen
Zoom in on the components that you have selected
Move the viewable area of your screen around the schema. To activate, select this tool
and then place the hand icon over and part of your schema. Click and drag the hand in
a direction to move around the schema.
Align the selected components to the top, middle, or bottom of the reference
component
Align the selected components to the left, middle, or right of the reference component
Evenly space the selected components across a horizontal axis, starting from the far
left component and ending at the far right component
Evenly space the selected components across a vertical axis, starting from the top
component and ending at the bottom component
Set the width of the selected components to the same width as the reference
component
Set the height of the selected components to the same height as the reference
component
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents