Gigaset USB Adapter 54 / English / A31008-E505-B104-1-19 / installation.fm / 26.02.2004
Installing the Gigaset USB Adapter 54
A USB cable can be inserted or removed while the PC is on. If the device has already been
installed, Windows will recognise it automatically.
Do not extend the USB cable.
Installing the software
To use all the features of your Gigaset USB Adapter 54, you should install the supplied
The Gigaset WLAN Adapter Monitor is the control software for your Gigaset USB
Adapter 54. This software not only includes the driver software for the USB device, it can
also be used as a configuration and monitoring tool.
Only this software has been written especially for the Gigaset USB Adapter 54. There are
similar drivers available in the Windows driver database. But, as a rule, such drivers do
not fully cover all the features or function in a different manner.
If you connect the Gigaset USB Adapter 54 to your PC before installing the software,
Windows will automatically recognise the device and display a message prompting for
the driver. Click on Cancel to close the dialogue. Remove the USB plug and then install
Do not insert the USB cable plug into a USB port on your PC until the
installation software prompts you to do so.
Make sure that you keep to the following order:
1. Install the software from the CD-ROM supplied.
2. Do not connect the Gigaset USB Adapter 54 to your PC until the
installation procedure prompts you to do so.
3. Install the drivers.
4. Configure the network using the Gigaset WLAN Adapter Monitor.
Please note that you may require administrator rights for the installation