Enabling Jumbo Frames; Enabling Lldp - Cisco Nexus 9504 Configuration Manual

The following configuration will be applied:
<Your settings will be displayed>
Would you like to edit the configuration? (yes/no) [n]: n
Use this configuration and save it? (yes/no) [y]: y
[########################################] 100%
Copy complete.
Log into the switch using the credentials you created.
Note: You must perform port configurations for each individual port that is connected to a storage
controller or a host server interface port, or you can specify a range of ports to configure. This example
assumes all 48 ports on Linecard Modules 1 and 2.
2.4

Enabling Jumbo Frames

switch# configure
switch(config)#system jumbomtu 9216
switch(config)# interface ethernet 1/1-48 , ethernet 2/1-48
switch(config-if-range)# mtu 9216
switch(config-if-range)#exit
Note: By default, Data Center Bridging (DCB) is enabled. This document will provide steps to disable
DCB. Perform all operations during a maintenance window, whereas a temporary loss of
communication between host servers and storage arrays may occur.
2.5

Enabling LLDP

switch(config)#feature lldp
switch(config)#interface ethernet 1/1-48 , ethernet 2/1-48
switch(config-if-range)# lldp receive
switch(config-if-range)# lldp transmit
switch(config-if-range)#exit
switch(config)#exit
8 SCG3252 | Cisco Nexus 9504 Switch Configuration Guide for Dell SC Series SANs