Upgrading The Wbs24 S/W; Upgrading Via The Web Browser - Samsung OfficeServ 500 Service Manual

CHAPTER 5. Maintenance
2

Upgrading the WBS24 S/W

WBS24 S/W is upgraded in the following two methods.
Use the web browser screen
Use the network booting
It is recommended to use the web browser method that the setting is easy and the
usage is simple.
When the WBS24 generates a fault due to the flash memory that is not
functioning(When all the 5 LEDs of the WBS24 blink, except the PWR LED), the
WBS24 can be recovered/upgraded using the network booting method.
2.1

Upgrading via the Web Browser

The method of using the web screen is different according to what types of the
WBS24 connection is made, whether by wire or by wireless. Each type is described
in the following section.
2.1.1 Wireless Connection
Preparing Materials
PC(PC or laptop computer is recommended) that is loaded with the WLAN
NIC(Network Interface Card) card.
Upgrade file for HTTP(tar type)
Upgrade Procedure
1) After placing the PC within about 10M from the WBS24, bring up the web
browser by connecting the IP address of the WBS24 wirelessly. The IP address
of the WBS24 is set from the system, and the established value can be inquired
through the MMC 845. Verify if the DASL status is 'Active(Config OK)' on the
connected web screen. If the status is not 'Active(Config OK)' after reloading
the web screen, wait for the active status.
Page 5-10
OfficeServ 500 Wireless LAN Service Manual/Ed.00
© SAMSUNG Electronics Co., Ltd.