ABB ACF-NT Operator's Manual page 26

Replacing the Filter Element in the Probe,
Replacing the
Filter Element
26
Step Action
1 Turn the T-handle 1 of the filter
removal device 1-3 in counter-
clockwise direction.
This pulls the filter element 8 via the
detaching disk 3 out of the casing
10.
2 Turn bridge 2 until it can be pulled off
from the bridge holding device 9
through the elongated holes.
3 Pull out filter element 8 with bridge 2
and detaching disk 3.
4 Turn detaching disk 3 until it can be
pulled off from the hexagon screws 5
via the elongated holes.
Never loosen or tighten the hexagon screws 5. They have been
adjusted at the factory so that the detaching disk 3 can be
easily moved.
Operator's Manual ACF-NT, ACF-NT V0309
continued
Continued on next page
42/23-572 EN Rev. 5