Mechanical Characteristics; Cosmetic; Mechanical Data Files; Location Of Philips Logo - Philips 191E2SB/00 Service Manual

104 Meridian 2

5. Mechanical Characteristics

5.1 Cosmetic -

Philips ID

5.2 Mechanical data files -

ProE files required

5.3 Location of Philips logo -

Per Philips make-up sheet

5.4 Gap between panel and front bezel

< 1.4mm (max.)
5.5 Location of Control icons -
Per Philips Graphic sheet

5.6 Color for resin/paint -

Per Philips make-up sheet

5.7 Fire enclosure request

Shielding Cover should fulfill international standard

5.8 Resins

RoHS required
WEEE required.
Resin type/selection refers to Project Book Section 7.2 Plastic material.

5.9 If paint is used

RoHS required
WEEE require
If new painting type needs to implement, refer to UN-D 1235.

5.10 Plastic mold tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.

5.11 Plastics flammability

All Plastics to be Flame Retardant UL 94-HB.
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool
5.12 Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
> = 80 gloss units
monitor".