Download  Print this page

Setting Up The Aed Trainer 3; Checking The Operating System Card; Installing The Batteries - Philips HeartStart FR3 Instruction Manual

Hide thumbs

Advertisement

4

SETTING UP THE AED TRAINER 3

To set up the AED Trainer 3 for operation, you will need to ensure that the
Operating System Card is properly installed, install the batteries (not
provided), select a different language if you do not wish to use U.S. English,
and connect the training pads. Instructions for each of these tasks follow.

CHECKING THE OPERATING SYSTEM CARD

The AED Trainer 3 Operating System Card contains the operating system for
the AED Trainer 3. The AED Trainer 3 is shipped with the Operating System
Card pre-installed. To remove, re-install, or replace the Operating System
Card, follow the steps below:
1.
Squeeze the latch on the battery
compartment lid to release the lid. Lift out
the lid and set it aside.
2.
Check that the Operating System Card is
installed in the slot at the top of the
compartment. If not, install the Operating
System Card in the orientation shown.

INSTALLING THE BATTERIES

The AED Trainer 3 requires four AA size
alkaline batteries (not included). To install or
replace the batteries in the AED Trainer 3,
follow the steps below:
1.
Squeeze the latch on the battery compartment lid to release the lid. Lift
out the lid and set it aside.
2.
Install four AA size alkaline batteries in the battery compartment
oriented as illustrated inside the compartment.
NOTE: Use only fresh batteries of the same type.
3.
Replace the battery compartment lid.
4.
Return the AED Trainer 3 to its case.

Advertisement

Table of Contents

This manual is also suitable for:

Aed trainer 3

Comments to this Manuals

Symbols: 0
Latest comments: