Related Manuals for Delta OHM HD37B17D
Summary of Contents for Delta OHM HD37B17D
- Page 1 English Operating manual Data logger Temperature – RH – CO – CO HD37AB17D – HD37B17D Companies / Brands of GHM www.deltaohm.com Keep for future reference.
- Page 2 Datalogger RH – Temperature – CO – CO HD37AB17D and HD37B17D - 2 - HD37AB17D/HD37B17D V1.5...
- Page 3 HD37AB17D – HD37B17D 1. Humidity and temperature sensor. 2. Wicket through which you can enter to the CO sensor (Carbon Monoxide) (only HD37AB17D). 3. It visualizes the working state of the instrument. 4. It offers the information about the charge state of the Ni-MH rechargeable bat- teries.
-
Page 4: Table Of Contents
4.1 . RH SENSOR CALIBRATION ..............12 4.2 . CO SENSOR CALIBRATION (ONLY HD37AB17D) ........13 4.3 . CO SENSOR CALIBRATION ..............15 5 . TECHNICAL FEATURES ................16 6 . STORAGE ....................17 7 . ORDER CODES ..................18 - 4 - HD37AB17D/HD37B17D V1.5... -
Page 5: Introduction
HD37AB17D and HD37B17D connect to the PC through USB inlet. The instruments are supplied with DeltaLog13 Software with which you can manage the connection operations to the PC, the RH, CO (only HD37B17D) and CO sensor calibrations, the instrument working parameters setup, the data transfer, the graphi- cal introduction and the acquired or memorized measurements print. -
Page 6: Keyboard And Led Description
The led ACTIVITY visualizes the working state of the instrument. Every 5 seconds, a short flashing indicates the stand-by mode. At least every 3 seconds, a double flash- ing indicates that the instrument is measuring. - 6 - HD37AB17D/HD37B17D V1.5... -
Page 7: Instrument Installation
• Maximum current: 1600mA (9,60 VA Max). The instrument is provided with a package of 2 Ni-MH rechargeable batteries at 1.2V– 2200mA/h, placed in the battery case. To recharge the batteries, follow the following instruction. - 7 - HD37AB17D/HD37B17D V1.5... -
Page 8: Batteries Recharge
Replace the batteries package when the autonomy is reduced at some hours. • Use only Delta Ohm batteries package code BAT-20 and recharge it using SWD06 battery charger or one that complies with the specifications indicated in the techni- cal data. -
Page 9: Replacement Of The Batteries Package
Close the batteries case again with the clamping screw. 3.1.4. Batteries disposal Recycle the batteries or throw them in a suitable manner. Don’t throw the batteries to the waste. Don’t throw the batteries into the fire. - 9 - HD37AB17D/HD37B17D V1.5... -
Page 10: Connection To The Pc
PC, the CO sensor calibration (only HD37B17D), the RH calibrations, the instrument working parameters setup, the data transfer, the graphical introduction, the acquired or memorized measurements print. DeltaLog13 software is endowed with a “Help on-line” (also in pdf format) that describes the features and the functions. - Page 11 (it’s accepted A00ZWUxx…x &| only if it is preceded by A00ZYU) It sets the average per package A00ZWAxx &| on xx samples (from 3 sec to 60 sec) A00ZWPxxxx &|0ZWP1013 Setup of atmospheric pressure - 11 - HD37AB17D/HD37B17D V1.5...
-
Page 12: Sensors Calibration
Once introduced the sensor, wait at least 30 minutes, if the probe and the salts have the same temperature. Follow the DeltaLog13 guided process for calibrating the sensor. - 12 - HD37AB17D/HD37B17D V1.5... -
Page 13: Co Sensor Calibration (Only Hd37Ab17D)
2. Connect the pipe coming from the MINICAN.12A cylinder with the rubber cowl- ing on the CO sensor head. 3. Connect the instrument to the PC by the USB connection cable code CP22 to the PC and start the DeltaLog13 guided process of sensors calibration. - 13 - HD37AB17D/HD37B17D V1.5... - Page 14 5. Switch the instrument on and wait at least 5 minutes till the measurement is stabilized. 6. Connect the instrument to the PC by USB connection cable code and start Del- taLog13 program, go to replace CO sensor. If necessary, execute the zero calibration of the new CO sensor. - 14 - HD37AB17D/HD37B17D V1.5...
-
Page 15: Co Sensor Calibration
7. Wait two minutes necessary for the calibration without modifying the working conditions. 8. Follow the DeltaLog13 guided process for calibrating the sensor. 9. At the end screw the instrument tube and close the hole with the grub screw with M6 hexagonal slot. - 15 - HD37AB17D/HD37B17D V1.5... -
Page 16: Technical Features
3, 6, 12, 15, 30, 60, 120, 180, Printing interval 240, 300 seconds. The printed values represent the average value of the samples that are stored every three sec- onds. - 16 - HD37AB17D/HD37B17D V1.5... -
Page 17: Storage
The instrument is exposed at a high temperature source. There are hard vibrations. There are vapour, salt and/or corrosive gas. The instrument case is in ABS plastic material: don’t use not compatible solvents for their cleaning. - 17 - HD37AB17D/HD37B17D V1.5... -
Page 18: Order Codes
T (temperature), DeltaLog13 Software, USB cable code CP22, SWD06 power supply, BAT-20 batteries package, instruction manual, case. HD37B17D The kit consists of: HD37B17D instrument to measure CO (Car- bon Dioxide), RH (Relative Humidity), T (Temperature), Delta- Log13 Software, USB cable code CP22, SWD06 power supply, BAT-20 batteries package, instruction manual, case. - Page 20 All DELTA OHM instruments are subject to accurate testing, and are guaranteed for 24 months from the date of purchase. DELTA OHM will repair or replace free of charge the parts that, within the warranty period, shall be deemed non efficient according to its own judgement. Complete replacement is excluded and no damage claims are accepted.
- Page 21 GHM GROUP – Delta OHM | Delta Ohm S.r.l. a socio unico Via Marconi 5 | 35030 Caselle di Selvazzano | Padova | ITALY Phone +39 049 8977150 | Fax +39 049 635596 www.deltaohm.com | info@deltaohm.com The quality level of our instruments is the result of the constant development of the product. This may produce some differences between the information written in this manual and the instrument you have purchased.
- Page 22 GHM GROUP – Delta OHM | Delta Ohm S.r.l. a socio unico Via Marconi 5 | 35030 Caselle di Selvazzano | Padova | ITALY Phone +39 049 8977150 | Fax +39 049 635596 www.deltaohm.com | info@deltaohm.com V1.5 13/11/2017...
Need help?
Do you have a question about the HD37B17D and is the answer not in the manual?
Questions and answers