LOWER CHUTE (See Figs. 7A & 7B)
Use Hardware - - GROUP "E"
1. Press weld nut into rubber latch and install two latch
hook assemblies to lower chute using screw, washer,
and lock washer as shown.
2. Tighten hardware securely.
3. Raise and hold deﬂ ector shield in upright position.
4. Place rear of chute over rear of mower deck opening.
Push chute down and forward to guide extended edge
of chute between discharge guard and mower deck.
5. Hook front latch into tab hole on front of mower deck.
6. Hook rear latch into ﬂ ange hole on back of mower
CAUTION: Do not remove discharge
guard from mower. Raise and hold guard
when at tach ing lower chute and allow it
to rest on chute while in op er a tion.
DE FLEC TOR