Table of Contents
Advertisement
Setup
B B efore you begin:
Make sure the Unit is connected to Antenna or Cable.
1
Press
and use
to select Setup, then press OK.
Picture
Autoprogram
Channel list
Sound
Add channels
Setup
Features
Antenna
Language
USB
2
Adjust the following items.
Autoprogram
Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
1
Use
to Select Autoprogram, then press OK.
•
If you run Autoprogram when you have Locked Channels, a
Message appears asking to enter your PIN. Enter your Child Lock
PIN in order to Complete the Installation. (Default PIN code is 0, 0,
0, 0.) You need to reset or set the Channel Lock again after the
Installation.
2
Use
to Select an appropriate Option, then press OK.
–When Antenna is selected, the TV Detects Any Off-the-Air
Antenna Signals. It searches for ATSC (Digital) and NTSC (Analog)
Channels available in your Area.
–When Cable is selected, the TV detects signals supplied by
Cable. It searches for DTV, Analog TV and Cable channels
available in your area.
Picture
Auto program will rescan all channels.
Auto programming may take more
Sound
than 20 minutes to complete.
Setup
####
Features
Select your signal source.
Language
Antenna
USB
Cable
Back
Antenna
Cable
Or
ANTENNA IN
Autoprogram
Please wait while the system is scanning for
channels.
Auto programming may take more than 20 minutes
to complete.
75%
Digital channels
Analog channels
•
When the Scanning and Memorizing of Available Channels is
Completed, the Lowest Memorized Channel will be Displayed.
Note(s)
•
After setting Autoprogram, using CH + / – skips unavailable channels Automatically.
•
If you are not receiving a signal from your Cable service, contact the Cable provider.
•
If you press
or
during Autoprogram, the Setup of TV channels will be Cancelled.
•
Even if Autoprogram is completed, the channel setting will be lost if the AC Power Cord is
unplugged before the Unit goes into Standby mode by pressing .
•
The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.
p. 27
•
If you want to change your PIN code, follow the instruction for Change PIN.
Channel list
The channels selected in the Channel list can be skipped when selecting
the channels using CH + / –.
These channels can still be selected with the NUMBER keys.
1
Use
to select Channel list, then press OK.
2
Use
to select the channel you want to remove, then press OK.
Picture
Sound
Highlight channels for Ch Up/Down
key selection.
Setup
Features
Language
USB
Ch Select
•
The channel display for the removed channel darkens. You will not
be able to select the channel again using CH + / –.
•
To reactivate a removed channel, use
registered channels are highlighted.
•
When you remove a main channel, its subchannels are removed
as well.
Note(s)
•
The channel with DTV indicated on the display is Digital TV (ATSC). Otherwise the channel is
Analog TV (NTSC).
24
10 ch
6 ch
Exit
p. 29
DTV
11.1
DTV
11.2
DTV
11.3
Watch / Skip
Back
and press OK. The
Continued on next page.
.
English
Advertisement
Table of Contents
