Philips 40PFL4701 User Manual page 16

7
Press OK to finish Settings assistant.
Settings assistant
You have set up your viewing preferences.
Store
•
When the initial setup is completed, the lowest memorized channel
with the confirmation message of the location setting will be
displayed on the TV screen.
•
You must set Home in step 4. Otherwise, Picture and Sound
settings you adjusted will not be memorized after the unit goes into
Standby mode.
Note(s)
•
If you are not receiving a signal from your Cable service, contact the Cable provider.
•
If you press or during Autoprogram, this Setup of TV channels will be Cancelled.
•
The Initial Autoprogram function can be executed for either Antenna or Cable only Once. When
you change the Connection (Antenna / Cable), select Autoprogram again.
p. 24
•
If there is no signal Input from the Antenna terminal and no operation for several seconds after
you Turn On the Unit, Helpful hints appears. Follow the instructions listed on the TV screen.
Initial setup
No channel is registered.
Try Autoprogram again?
Verify that you have a cable connected to the
ANTENNA IN jack on the back of the TV, the channel
installation process searches this connection.
If you are using a cable or satellite box, please confirm
the input which you have connected to the box and
press "SOURCE" key on the remote control to select
the appropriate source input.
####
####
Select
OK
After an Initial Setup is completed...
•
If you want to scan the channels Automatically again.
p. 24
Autoprogram
•
You can add the desired Cable and Analog channels not memorized
by Autoprogram.
p. 25
Add channels
•
If you want to change to another Language.
p. 31
Language
•
If you want to change the Location setting.
p. 30
Location
•
If you want to restore the picture setting.
p. 22
Settings assistant
Back Exit
Retry
Later
Skip
16
.
English