Philips SCF870/20 Service Manual page 6

DISASSEMBLY- AND RE-ASSEMBLY ADVISE
7th operation: Detaching the soldering of microswitch
- Cut the shrinkage sleeves on the microswitch terminals and remove the sleeves.
- Remove the soldering on the terminals by using a soldering iron.
ATTENTION: If the soldering iron is kept near the microswitch more than 3 seconds, switch may be non functional.
RE-ASSEMBLY
1st operation: Putting the shrinkage sleeves on the cables and soldering the cables on the microswitch terminals and heating
the shrinkage sleeves
- Put the shrinkage sleeves on the cables which are previously detached.
- Insert the cable inside the hole on the microswitch terminal and bend it as shown in the photo below.
- Make the soldering to connect the cable and microswitch terminal.
ATTENTION: If the soldering iron is kept near the microswitch more than 3 seconds, switch may be non functional.
- After the soldering process is fi nished, slide the shrinkage sleeve on the soldered area until it touches the switch body.
- Shrink the sleeve by using a heating gun.
SCF870/20 /21 /22 /23
6-9