Instructions To The Homeowner; Turning Off The Appliance - Honeywell VR8215S Installation Instructions Manual

INSTRUCTIONS TO THE HOMEOWNER

WARNING
Fire or Explosion Hazard.
Can cause property damage, severe injury,
or death.
Follow these warnings exactly:
1. Before lighting, smell around the appliance
for gas. Be sure to smell next to the floor
because LP gas is heavier than air. If you
smell gas:
a. Turn off the gas supply at the appliance
service valve. On LP gas systems, turn off
the gas supply at the gas tank.
b. Do not light any appliances in the house.
c. Do not touch electrical switches or use the
phone.
d. Leave the building and use a neighbor's
phone to call your gas supplier.
e. If you cannot reach your gas supplier, call
the fire department.
2. Replace the gas control in the event of any
physical damage, tampering, bent terminals,
missing or broken parts, stripped threads, or
evidence of exposure to heat.
IMPORTANT
Follow the operating instructions provided by
the heating appliance manufacturer. The
information below describes a typical control
application, but the specific controls used and
the procedures outlined in your appliance
manufacturer instructions can differ, requiring
special instructions.
VR8215S,T SINGLE STAGE VR8215Q,N TWO STAGE DIRECT IGNITION GAS CONTROLS
To Turn ON Appliance
STOP! Read the Warnings
Above Before Proceeding.
1. The lighting sequence on this appliance is
automatic; do not attempt to manually light the
main burner.
2. If the furnace does not come on when the
thermostat is set several degrees above room
temperature, set the thermostat to its lowest
setting to reset the safety control.
3. Remove the burner access panel if provided on
your appliance.
4. Push the on-off switch to the OFF
position.
5. Wait five minutes to allow any gas in the
combustion chamber to vent. Then if you smell
gas, STOP! Follow Step 1 in the Warning above. If
you do not smell gas, continue with the next
step.
6. If you do not smell gas, push the electronic on-
off switch to the ON position.
7. Replace the burner access panel.
8. Reset the thermostat to the desired temperature.
9. If the appliance does not turn on, turn the gas
control switch to OFF and contact a qualified
service technician for assistance.

Turning Off the Appliance

Vacation Shutdown
Set the thermostat to the desired room temperature
while you are away.
Complete Shutdown
1. Turn off power to the appliance.
2. Turn off the gas supply to the appliance.
3. Push the on-off switch to the OFF
position. Appliance will completely shut off.
4. Follow the procedure in the Instructions to the
Homeowner section above to resume normal
operation.
11 69-2253—07