Danfoss ECL Comfort 210 Operating Manual page 90

Operating Guide ECL Comfort 210 / 310, application A231 / A331
5.10.2 Clear alarm
Clear alarm
If an alarm has been generated, a bell
the favorite display (see 'Monitoring temperatures and system
components') or in an overview display (see 'Understanding the
controller display'). The following menus are used to locate the
alarm cause and reset (clear) the alarm signal. Even when the cause
of the alarm has disappeared, the indication will still be active until
the clear alarm procedure has been carried out.
MENU > Settings > Alarm
Circ. pumps
Choose whether the alarm should be cleared or not.
See Appendix "Parameter ID overview"
OFF:
The alarm has not been activated.
ON: The alarm has been activated.
Clear alarm procedure:
If the status is 'ON': Change 'ON' to 'OFF' .
If the status is 'OFF': It is not possible to change it to 'ON' .
MENU > Settings > Alarm
Refill water
Choose whether the alarm should be cleared or not.
See Appendix "Parameter ID overview"
OFF: The alarm has not been activated.
ON: The alarm has been activated.
Clear alarm procedure:
If the status is 'ON': Change 'ON' to 'OFF' .
If the status is 'OFF': It is not possible to change it to 'ON' .
90 | © Danfoss | 2017.11
is shown in one of
1x315
1x324
VI.LG.P2.02