Table of Contents
Advertisement
If call timer has been set to ON, then after 8 seconds of
no further key press, the call timer counter will display. It
starts counting from ‘00: 01’ when off hook.
To terminate the call, press [
]. The last call time will
remain for 2 seconds.
The call can also be terminated by putting the handset on
cradle. In that case, the call time will also be displayed
for 2 seconds.
Pre-dialing
A user may enter the number (up to 25 digits) before
seizing the line as shown;
Press [C/ ] to delete the last input digit. To add a pause
digit, press [
/P] and a letter ‘P’ will be shown. Long
Press the [C/ ] key can clear all digits at once.
After the desired number is entered, press [
] to seize
line and the entered number will be dialed out.
Redialing
During standby mode, press [
/P] will show one of the
10 last dialed numbers.
If the number is longer than 12 digits, at first, the first
page will be shown aligning right, the digit number
equals to the total number minus 12.
2s later, the second page (the rest 12 digit) will be
displayed.
Press [
/P] to view another last dialed number in the
list. Or press [MENU/
] [
/
] to view the former or
later number.
Press [
] to seize line and the selected number will be
redialed.
Recalling a number from the phone book
directory
To store a number into the directory, please refer to the
menu functions.
To retrieve the number stored in the phone book memory
during standby mode, press [R/
] and the name for the
first number stored in a sorted listed in the directory will
be shown.
Users may like to press the keys [1] – [9] and [MENU/
]
[
/
] key to locate the desired entry. For example,
press [8 TUV] to locate the entry with the name started
with ‘T’. Press [6 MNO] to locate the name started with
‘M’.
Press [
] to dial out the number immediately.
If the phone book is empty, an error tone will be heard
following with an error message.
The error message will be displayed for 2 seconds before
reverting to standby mode.
*
Call log reply
During standby mode, press [
/
] to view unread
caller ID or through menu to browse call log list.
To call back to the caller, press [
] and the viewed
number will be dialed out.
Temp tone dial
A user may like to change to DTMF dialing temporary
during the call if the call has been setup for pulse dialing.
This can be done by pressing [*/
] key for more than
2 seconds during the call is active. A digit ‘d’ will be
*
Page 8
Advertisement
Table of Contents
