Change Dtmf/Pulse Dialing; Outgoing Call Barring; De-Registration; Change Flash Time - GE HWDCD3988(3)P/TSD User Manual

Change DTMF/Pulse Dialing

The DTMF or pulse dialing mode can be selected by
choosing 'Dial Mode' from the base setting menu.
After selecting, the current dial mode is shown;
Press [ / ] or [MENU/
dial mode. Press [INT/OK] to confirm or press [C/ ] to
abort.

Outgoing Call Barring

External call barring: All external outgoing calls must be
barred.
Number: All outgoing calls begin with the specifically
number must be barred.
Disable: All calls are allowed.

De-registration

One of the registered handset is able to remove the
registration of another handset.
Select 'DEREG HS' from the menu, user will be asked
to enter the handset number to be deleted
For safety purpose, a handset cannot delete itself. So, the
handset number is shown for other handset. In case
that there is only one handset registered, the
de-registration procedure will be aborted.
Press [INT/OK] to proceed. That handset will no longer
be able to access the base. The 'Aerial' icon
disappear and 'NOT RGSTRD' will appear.

Change Flash Time

The flash time can be changed so that the base can be
compatible to different PABX system. Choose 'Flash
Time' from the base setting menu and the current setting
is displayed.
Three different flash time can be selected (100ms,
300ms or 600ms) by pressing [MENU/
Press [INT/OK] to confirm the selection.

Clear Message Waiting

Clear message waiting indicator on base and stop LED
flashing.

Reset Base Default setting

Similar to the resetting procedure for handset,
confirmation will be required.
Once confirmed, all the base setting parameters will be
reset to factory setting.

Registration

To register a handset to a base station, the base has to be
ready for registration. The base will be ready for
registration for 2 minute when [
hold for 3 seconds.
After selecting 'REGSTER', the handset starts searching
for a base station that is available for registration. The
'Aerial' icon starts flashing.
If success, the registration procedure will be completed
with a confirm tone. If fail, after 60 seconds, the
registration procedure will be exited with an error tone.

Change Language

Select 'Language' from the manual and user will be
] to select DTMF or pulse
] or [ /
*
] key is pressed and
15
will
].