Radio Shack 60-4436 Owner's Manual
  1. Manuals
  2. Brands
  3. Radio Shack Manuals
  4. Motorized Toy Car
  5. 60-4436
  6. Owner's manual
Radio Shack 60-4436 Owner's Manual

Radio Shack 60-4436 Owner's Manual

1969 chevrolet camaro hot rod rc car 1/6
Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Owner's Manual draft as below:
RadioShack
1969 CHEVROLET CAMARO HOT ROD
60-4436
what's included
Vehicle, transmitter, box wrench
Step One

Installing Batteries

You will need...
One 9-Volt battery for the transmitter (not supplied).
One 7.2-Volt rechargeable nickel-cadmium (Ni-Cd) or nickel-metal-hydride (Ni-MH), battery
pack for the CAMARO (not supplied).
The rechargeable battery pack and battery pack charger, as well as alkaline battery, are available at
your local RadioShack store.
Put Batteries in the CAMARO
· Turn off the Vehicle
Use a coin to turn the latches on the battery compartment cover toward OPEN. Lift and remove
the cover.
· Insert the battery pack with it's connector on the same side as the vehicle's connector.
· Attach the battery pack and the vehicle connectors. They fit together only one way. Do not force
them.
· Replace the cover and turn the latches to secure it.
Put Battery in the Transmitter
. Open the battery compartment cover.
. Insert one 9V battery in the battery compartment, and match the polarity symbols (+ and -) as
marked inside.
. Replace the cover and snap it shut.
NOTE:
· If your vehicle does not respond to the transmitter or the transmitter's range
-
decreases, replace the 9V batteries in the transmitter.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 60-4436 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Radio Shack 60-4436

Summary of Contents for Radio Shack 60-4436

  • Page 1 Owner’s Manual draft as below: RadioShack 1969 CHEVROLET CAMARO HOT ROD 60-4436 what’s included Vehicle, transmitter, box wrench Step One Installing Batteries You will need… One 9-Volt battery for the transmitter (not supplied). One 7.2-Volt rechargeable nickel-cadmium (Ni-Cd) or nickel-metal-hydride (Ni-MH), battery pack for the CAMARO (not supplied).
  • Page 2 If the vehicle loses power, replace or recharge the battery pack Step Two Driving the CAMARO . Extend the transmitter’s antenna to its full length. . Turn ON your vehicle. The red LED light on dashboard starts blinking to indicate the car is security locked.
  • Page 3 · If you do not plan to use your vehicle for a week or more, remove the battery from the transmitter and the battery pack from the vehicle. Batteries can leak chemicals that may destroy electronic parts. · Never leave dead or weak batteries in the vehicle or transmitter. ·...
  • Page 4 . If the vehicle does not drive in a straight line, adjust the wheel alignment control on the bottom of the vehicle. [ The FCC Wants You to Know] FCC NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

Table of Contents