5. Mount any option module onto the DIN rail in the same way. Slide the module firmly into the controller's connector to seat. Repeat for other
modules as needed. A maximum of 4 option modules can be installed for each controller.
6. Carefully secure both ends of the final assembly with DIN rail end-clips provided by the DIN rail vendor.
• To remove a unit from the DIN rail, pull down its locking clip. Then swing the bottom out and lift the unit away from the DIN rail.
Figure 6: Mounting on DIN rail.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.