Download  Print this page

Changing Monitor Settings; Checking Your Monitor Revision - Philips M8102A Instructions For Use Manual

Patient monitor.
Hide thumbs

Advertisement

2 Basic Operation
Label Compatibility
When a new measurement is introduced, or new labels for an existing measurement, these labels will
not be shown on older Information Centers, and consequently not on the Overview screen sourced
from the Information Center.
When a patient is transferred from a monitor with these new labels to one with an older software
revision, the labels will be replaced with a generic label for that measurement. The settings for that
generic label will then be used.
If it is critical that the measurement labels are available at the Information Center and after transfers,
the older monitors and the Information Center must be upgraded to the appropriate software revision.

Changing Monitor Settings

To change monitor settings such as brightness, or QRS tone volume:
Press the SmartKeys key
1
Either Enter the Main Setup menu by selecting the SmartKey
2
want to change, or select User Interface to enter a submenu where you can change user
interface settings.
Or Select the appropriate SmartKey for the setting you want to change.
Adjusting the Screen Brightness
1
Select the Brightness SmartKey.
Select the appropriate setting for the screen brightness. 10 is the brightest, 1 is the least
2
bright. Optimum is suitable for most monitoring locations and optimizes power usage
for battery powered monitors.
Your monitor may be configured with a lower brightness for Standby mode and also for transport to
conserve battery power. These settings can only be changed in the monitor's Configuration Mode.
Setting the Date and Time
If your monitor is connected to an Information Center, the date and time are automatically taken from
this.
Once it is set, the internal clock retains the setting even when you switch off the monitor.
In the Main Setup menu, select Date, Time.
1
Select, in turn, the Year, Month, Day, Hour (in 24 hour format, only) and Minute as
2
necessary. Select the correct values from the pop-up list.
Select Store Date, Time to change the date and time.
3

Checking Your Monitor Revision

Select Main Setup -> Revision to open the Monitor Revision menu.
1
2
Select the correct device from the device pop-up keys.
30
.
Changing Monitor Settings
. Select the setting you

Advertisement

Table of Contents

This manual is also suitable for:

Intellivue mp2M3016aM3012aM3014aM3015a

Comments to this Manuals

Symbols: 0
Latest comments: