Download  Print this page

Understanding Settings - Philips M8102A Instructions For Use Manual

Patient monitor.
Hide thumbs

Advertisement

2 Basic Operation
If you switch to a different profile, the patient category and paced status normally change to the setting
WARNING
specified in the new profile. However some profiles may be setup to leave the patient category and
paced status unchanged. Always check the patient category, paced status, and all alarms and settings,
when you change profiles.
When you leave Demonstration Mode, the monitor uses the default profile.
Swapping a Complete Profile
1
Press the SmartKeys key and
– Either select Main Setup and then Profiles in the Setup menu.
– Or select the Profiles SmartKey
In the Profiles menu, select Profile.
2
Chose a profile from the pop-up list.
3
Confirm your selection.
4
Swapping a Settings Block
Select the Main Setup SmartKey and then Profiles in the Main Setup menu, or
1
select the Profiles SmartKey.
2
In the Profiles menu, select Display or Measmnt. Settings or
Monitor Settings to call up a list of the settings blocks in each category.
Choose a settings block from the pop-up list.
3
Confirm your selection.
4
Default Profile
Your monitor has a default profile that it uses when you leave Demonstration, or Service modes, or
when you discharge a patient. This profile is indicated by a diamond
Locked Profiles
Some profiles are locked, so that you cannot change them, even in Configuration Mode. These are
indicated by this lock symbol.

Understanding Settings

Each aspect of how the monitor works and looks is defined by a setting. There are a number of
different categories of settings, including,
Screen Settings, to define the selection and appearance of elements on each individual Screen
Measurement settings, to define settings unique to each measurement, for example, high and low
alarm limits
26
.
.
Understanding Settings

Advertisement

Table of Contents

   Related Manuals for Philips M8102A

This manual is also suitable for:

Intellivue mp2M3016aM3012aM3014aM3015a

Comments to this Manuals

Symbols: 0
Latest comments: