Download  Print this page

Philips M8102A Instructions For Use Manual Page 183

Patient monitor.
Hide thumbs

Advertisement

Setting up all CO
Measurements
2
Correction
O
2
(M3014A
only)
Humidity
N
O
2
(M3016A
mainstream
and M3015A
microstream
only)
Gas
(M3014A
only)
Agent
(M3014A
only)
Suppressing Sampling (not Mainstream CO
To temporarily stop sampling,
in the Setup CO
available.
Selecting Pump 15Min Off again before fifteen minutes have passed resets the timer to fifteen
minutes.
To re-start the pump,
in the Setup CO
Changing CO
2
This refers to CO
You change CO
To switch etCO2 alarms on and off:
Select etCO
To change the etCO
• Touch the high limit on the alarm limits menu button. Choose the high alarm limit from the pop-
up list that opens.
• Touch the low limit on the alarm limits menu button. Choose the low alarm limit from the pop-up
list that opens.
In the Setup CO
100%, the default value is 20%. If you are not measuring the expired O
subtracting
5% from the inspired O
At installation, the monitor is configured to automatically apply either
Pressure Saturated (BTPS) or Ambient Temperature Pressure Dry (ATPD). To see
which, go to the Setup CO
HumidityCorr
.
In the Setup CO
in the ventilation gas mixture, you must turn this on.
If the N
O correction is not available in the Setup CO
2
measurement in your MMS Extension does not require N
with Gas Corr. (see below).
In the Setup CO
If Helium or N
O is present in the ventilation gas mixture, you must make the
2
appropriate selection.
If the Gas correction is not available in the Setup CO
in your MMS Extension does not require N
correction is setup with N
In the Setup CO
anesthetic agent (between 0.0% and 20.0%). If an anesthetic agent is present in the
ventilation gas mixture, you must select the appropriate concentration.
menu, select Pump 15Min Off or use the CO
2
menu, select Pump On.
2
Alarms
specific alarms. See the Alarms section for general alarm information.
2
alarm settings in the Setup CO
2
Alarms and toggle between On and Off.
2
alarm limits:
2
menu, select Oxy. Corr and select a value between 20% and
2
then select the nearest value from the list.
2
menu, and scroll down to look at Hum. Corr
2
menu, select N
O Corr. and turn on or off. If N
2
2
menu, select Gas Corr. and select Helium, N
2
O Corr. (see above).
2
menu, select Agt. Corr. and select the concentration of the
2
menu.
2
14 Monitoring Carbon Dioxide
menu, the CO
2
O correction or it is setup
2
menu, the CO
2
O or Helium correction or the N
2
)
2
Pump Off SmartKey if
2
, estimate it
by
2
Body Temperature
or
O is present
2
2
O or turn off.
2
measurement
2
O
2
175

Advertisement

Table of Contents

This manual is also suitable for:

Intellivue mp2M3016aM3012aM3014aM3015a

Comments to this Manuals

Symbols: 0
Latest comments: