Presetting Channels - Sony KV-25FXR20 Operating Instructions Manual

Presetting Channels

Presetting channels automatically
You can preset TV channels in numerical sequence
from program position 1.
1
Press POWER.
POWER
If the TV is in standby mode after you have pressed
POWER, press POWER on the remote control.
2
Press CABLE to set cable TV on or off.
CABLE ON
3
Press AUTO PGM.
2 3
AUTO PROGRAM
CABLE
CABLE OFF
AUTO PGM
4 2
Presetting channels manually
To change the program position for a channel or to
receive a channel with a weak signal, preset the
channel manually.
1
Press CH +/– until the channel appears on
the screen.
2
Press number buttons to select the program
position, then press ENTER.
3
Press ADD.
"+" appears beside the channel position number,
indicating that presetting is complete.
ADD
Disabling program positions
By disabling unused or unwanted program positions,
you can skip those positions when you press AUTO
PGM +/–.
1
Press CH +/– until the unused or unwanted
program position appears on the screen,
then press ENTER.
2
Press ERASE.
"–" appears beside the channel position number,
indicating that disabling is complete.
ERASE
To cancel the skip setting
Preset the channel manually or automatically again.
+25
–25
7
Getting Started