Sets the sweep rate for all waveforms (displayed and printed), except CO2.
To open the Sweep Speed menu
Press the Setup key and then the Monitor
key. On the Monitor Setup menu, select
The following speeds (in millimeters per
second) are available:
To adjust the sweep rate for all waveforms (except CO2)
Sets the sweep rate for the CO2 waveform.
To open the Resp Speed menu
Expression MR400 Instructions for Use Getting Started 3‐25
25 mm/s (Default)
Press the Setup key and then the Monitor key.
The Monitor Setup menu appears. Current settings are displayed.
On the Monitor Setup menu, select Sweep Speed.
The Sweep Speed menu appears. The current setting is highlighted.
Select the desired setting from the menu options:
The setting is entered.