Troubleshooting; Helpful Tip; Specifications - Poulan Pro PP3516AVX, PP4218AVX Instruction Manual

Poulan pro chain saw instruction manual
Hide thumbs Also See for PP3516AVX, PP4218AVX:
Table of Contents

Advertisement

HELPFUL TIP

During storage of your gas/
oil mixture, the oil will sepa-
rate from the gas.
We recommend that you
shake the gas can weekly
to insure proper blending of
the gas and oil.
ENGINE
S Remove spark plug and pour 1 teaspoon
of 40:1, 2-cycle engine oil (air cooled)
through the spark plug opening. Slowly
pull the starter rope 8 to 10 times to distrib-
ute oil.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect spark plug before performing all of
the recommended remedies below except remedies that require operation of the unit.
TROUBLE
CAUSE
Engine will not
1. Ignition switch off.
start or will run
2. Engine flooded.
only a few
seconds after
3. Fuel tank empty.
starting.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
1. Idle speed requires
Engine will
adjustment.
not idle
2. Carburetor requires
properly.
adjustment.
Engine will not
1. Air filter dirty.
accelerate,
2. Spark plug fouled.
lacks power,
3. Chain brake engaged.
or dies under
4. Carburetor requires
a load.
adjustment.
Engine
1. Too much oil mixed with
smokes
gasoline.
excessively.
1. Idle speed requires
Chain moves
at idle speed.
adjustment.
2. Clutch requires repair.
S Replace spark plug with new one of rec-
ommended type and heat range.
S Clean air filter.
S Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.
S At the beginning of the next season, use
only fresh fuel having the proper gasoline
to oil ratio.
OTHER
S Do not store gasoline from one season to
another.
S Replace your gasoline can if it starts to
rust.
REMEDY
1. Move ignition switch to ON.
2. See "Difficult Starting" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents