Download  Print this page

Electrolux EHT6047X User Manual page 8

Gas cooktop
Hide thumbs

Advertisement

installation
4. Fitting the cooktop into the bench. Carry out as follows.
Place the rubber seal provided around the edge of the hob.
NOTE: The rubber seal has talc powder applied to it's
surface which should be wiped off with a damp cloth
after the unit has been installed.
Figure 6
rubber seal
hob
benchtop
clamp
Fit the pull-down clamps supplied to ensure that the
cooktop cannot move after installation.
warning
Failure to fix the cooktop to the bench could result in loosening of
the gas connection through movement of the cooktop and a gas
leak may result.
Use the 4 clamps and 4 screws supplied in the parts bag.
To assemble, attach the 4 clamps to each corner of the
burner box via the screw provided.
When placing the cooktop in the cut-out, swing the
clamps parallel with the box to avoid interference with the
cut-out.
Position the cooktop so it is centred, then swing the
clamps under the benchtop and tighten.
8 INSTALLATION Gas Cooktops
burner box
screw
Figure
Figure
warning

Advertisement

loading