Setting Up Your Handset; Install The Battery; Connect The Charger - Uniden DRX402 User Manual

Setting Up Your Handset

Install the Battery

1. Unpack the handset, battery pack, and
battery cover. If the battery cover is
already on the handset, press in on
the notch and slide the cover down
and off.
2. Line up the battery pack
connector with the jack inside
the handset. (The battery
connector only fits one way.)
3. Push the battery pack
connector in until it clicks into
place. Tug gently on the wires
to make sure the battery pack
is securely connected.

Connect the Charger

1. Connect the AC adapter to
the charger's
AC IN 6.5V
and route the cord as shown.
(This adapter might already
be connected.)
2. Plug the other end of the
adapter into a standard 120V
AC power outlet.
4. Place the cover over the battery
compartment and slide it up into
place.
jack
3