Following command is for Duplex printing functions.
2.2.38 Select Thermal Printing Modes
ASCII:
Hexadecimal:
Value of n:
Values of i:
This command specifies either simplex or duplex printing mode. If the mode is changed (Simplex -> Duplex,
Duplex -> Simplex) by this command, the remaining data in the printer is printed out by force.
This setting of this command will be issued as the setting of the printer in the printer driver menu as below.
2.2.39 Select Thermal Printing Side
ASCII:
Hexadecimal:
Value of n:
Default:
Values of i:
This command specifies the printing side in the duplex printing mode. The printing side can be changed
several times freely on a logical page. This command is ignored in simplex printing model.
US b n i
1F 62 n i
0 = Simplex Mode (Front)
1 = Simplex Mode (Back)
2 = Duplex Mode
Reserved (0x00)
US c n i
1F 63 n i
0 = Front Side
1 = Back Side
0 (Front Side)
Reserved (0x00)
23
DB-EA4D Command manual (rev.00)