Advertisement
condenserfan
condensercoil
blower motor
compressor
pressure switch
gas
manifold
gas valve
combustion
air inducer
burner box
control box section
heatexchanger
assembly
Figure
1
1 - Assembled gas package unit
1 - Vent hood assembly with screen and screws
As soon as the unit is received, it should be inspected for
possible damage during transit. If damage is evident, the
extent of the damage should be noted on the carrier's
freight bill. A separate request for inspection by the carrier's
agent should be made in writing.
These installation instructions are intended as a general
guide only, for use by an experienced, qualified contractor.
The 10GCS and 12CGS units are single-package
air
conditioners with gas heat designed for outdoor installation
on a rooftop or a slab.
The units are completely assembled. All piping, refrigerant
charge, and electrical
wiring are factory
installed and
tested. The units require only electric power, gas piping,
condensate drain and duct connections plus assembly of
heating rain hood at the point of installation.
NOTE - These units must not be used as a construction
heater at any time during any phase
of construction.
Very low return air temperatures,
harmful vapors, and
misplacement
of the filters will damage the unit and its
efficiency.
WARNING
Page 4
Advertisement
