Attaching The Pendant Pipe Mount Or Pendant Wall Mount; Making Connections In Unit - Bosch NDA-U-PA0 Installation Manual

Surveillance Cabinet
3.6

Attaching the Pendant pipe mount or Pendant wall mount

To attach accessories such as a Pendant pipe mount or Pendant wall mount, refer to the
documentation that comes with your accessory.
Notice!
The accessory comes with a watertight plug. When you attach the accessory to the door,
always use the plug to make a watertight cable feed through.
3.7

Making connections in unit

Make the connections in the unit, depending on your camera model.
1.
2.
3.
4.
5.
6.
7.
Notice!
Make sure that you tighten the screws to 10-12 N-m (90-105 in.-lbs) to ensure the unit is
watertight.
Bosch Security Systems
Connect the ground wire to the grounding screw on the left side of the unit.
Connect all wires from the camera to their mating wires in the unit. (For Fiber Optic
models: connect the 6-pin Control to Dome Plug to the P106 connector.)
Connect the 5-pin, 24 VAC to Dome Plug to connector P107 with corresponding color on
the right side of the unit.
Connect the 3-pin Power In Plug to its mating connector P101 on the left side of the unit.
Attach the grounding strap of the Pendant arm to the unit.
After making the connections to the unit, rotate the Pendant arm to close and seal the
unit and tighten the 2 captive screws to 10‑12 N-m (90-105 in.-lbs).
Refer to Attach Pendant to Arm and Tighten to continue the installation procedure.
Installation manual
Installing the Surveillance cabinet | en
2017.09 | v1.0 | F.01U.250.239
19