The 4200 series dovetail jigs come fully assembled from the factory. However, the accessory templates (4211, 4213,
4215) require assembly. The supplied hex wrench can be used to attach the brackets and router bit depth guides
to the template. A 3/8" wrench is required to adjust the height of the router bit depth guide.
ADDITIONAL TOOLS REQUIRED
The router that you use with this jig
u must accept the Porter-Cable template guides supplied with the
jig. (Adapters and sub-bases are available for most routers.)
must have a 1/2" collet for use with 4210 and 4212 jigs and the
4211 and 4213 accessory kits.
must have a 1/4" collet for use with the 4215 accessory kit.
NOTE: While the jigs and accessory kits include the router bits and template guides to make the basic dovetail
joints, additional router bits are required to make box joints.
NOTE: Always mount your jig to a solid work surface.
You can mount your jig permanently (Fig. B1) by using the pre-drilled holes (A) Fig B1) on each side of the base, or
you can mount the base to your work surface using clamps (Fig. B2).