Start Up - Kärcher K 2 Premium Operating Instructions Manual

Attaching the Accessories
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 3
Illustration
 Insert the transport wheels and lock
them.
Illustration
 Attach the transport handle.
Illustration
 Pull the suction hose for detergent
through the cover of the detergent tank
until the filter contacts the bottom of the
tank.
 Close the detergent tank with the lid.
 Lock the detergent tank in place on the
appliance.
Illustration
 Screw the coupling element to the wa-
ter connection on the appliance.
Illustration
 Pull out the clamp for the high-pressure
hose from the hand spray gun (e.g. a
Philips screwdriver).
Illustration
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Water supply
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
WARNING
According to applicable regulations, the ap-
pliance must never be used on the drinking
water net without a system separator. A
suitable system separator by KÄRCHER or
alternatively a system separator according
to EN 12729 type BA must be used.
Water that has flown through a system sep-
arator is no longer classified as drinking
water.
ATTENTION
Always connect the system separator to the
water supply, never directly to the appliance!
ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.

Start up

ATTENTION
Dry running of more than 2 minutes leads to
damage of the high-pressure pump. If the
appliance does not build up pressure within
2 minutes, switch the appliance off and pro-
ceed in accordance with the instructions in
Chapter "Troubleshooting".
Illustration
 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
 Attach the water supply hose to the
coupling on the water connection.
Note: The supply hose is not included.
 Connect the water supply hose to the
water supply.
 Completely open the water tap.
 Insert the mains plug into the socket.
 Turn on the appliance "I/ON".
Illustration
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Switch the appliance on for a (max. of 2
minutes) and wait until the water exits at
the hand spray gun without bubbles.
 Release the lever on the trigger gun.
Note: Release the lever of the trigger
gun; the device will switch off again.
High pressure remains in the system.
Illustration
 Lock the lever on the trigger gun.
English 9