Table of Contents
Advertisement
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part
to the door. Refer to the image.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
Residual heat indicator does not
come on.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
www.zanussi.com
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
4. Install the glass cover.
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
The zone is not hot because it
operated only for a short time.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
deactivate the circuit breaker.
The lamp glass cover is at the back
of the cavity.
to remove it.
°C heat-resistant oven lamp.
Use the same oven lamp type.
Check if the appliance is correct-
ly connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
Remedy
21
Hide quick links:
Advertisement
Table of Contents
